Evinrude & Johnson 587280 Manuel D'instructions page 6

Install shift actuator on mounting plate with three
long screws and one short screw. Install battery
cable clamp with forward screw.
Tighten all screws, including support clamp
screw, to a torque of 60 to 84 in. lbs. (7 to 9.5
N·m).
1
Connect actuator harness connector to harness
from ESM and attach to clip on mounting plate.
1. Shift actuator harness connector
IMPORTANT: Do not install shift link until the
calibration procedure has been completed. Refer
to Actuator alignment and calibration on
p. 10.
INSTALL THROTTLE ACTUATOR
Install support clamp loosely over throttle
actuator motor. Route ESM to shift actuator
harness behind motor as shown.
Install throttle actuator on mounting plate with
three long screws and one short screw. Tighten
6 of 14
all screws, including support clamp screw, to a
torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
1
2
1. Support clamp
2. Shift actuator harness routing
Use Ball Socket Installer tool, P/N 342225, to
install new throttle link onto actuator arm.
008235
1
Connect actuator harness connector to harness
from ESM.
008236
1
1. Harness connector
ESM ELECTRICAL CONNECTIONS
Connect ESM harness to engine harness key
switch and trim/tilt connectors.
2
008237
008238
008239