monoTIG 220ip / 220ipw / 220ip AC-DC / 220ipw AC-DC
• It ensures that the idle voltage (voltage between the output terminals) is reduced below 12V
Voltage Reduction
when the machine is running and no welding is performed.
• It may be required within the framework of occupational health and safety rules.
• Applies in electrode welding modes.
• Activate or deactivate by pressing the button. The LED will light when active.
7- AC Frequency and Balance Adjustment
Press the button once to switch between the parameters. These keys are available only on AC/
DC models. Adjustment is made with the adjustment knob.
• Used to adjust the output frequency of the AC output poles when AC mode is active in TIG
AC Frequency
welding mode.
• Allows adjustment between 5-150 Hz.
• The factory default setting is 60 Hz.
• By this function, it is easier to break the oxide layer of the material.
• AC determines how fast the pole change will occur.
AC Balance Adjustment
• Allows amplitude adjustment when the AC mode is active in TIG welding.
• Has a setting range of 10-90%.
• By this function, the breakage of the oxide layer and the smoothness of the welding seam
after breakage will be finely adjusted according to the material thickness and tungsten
diameter.
• The default factory setting is 35%.
• Will be replaced depending on the workpiece thickness and user request.
Let AC balance be set to 35% welding and penetration will be provided at 65% and at alu-
Example;
minum oxide will be cleaned 35% .
8- Program Memory
• With its 100 program memory feature, it can save your parameter settings. You can recall them as
TIG Mode;
required by your work type. By this means, each time you change the work, you will not have to set
parameters; the production standard will be preserved. Whichever memory (job) number is
selected, all settings will automatically be saved in that number.
• Change the program number for different parameter entries.
• The display above the program button shows which parameter you have changed in the program.
• There are 100 programs available between 0-99.
• You can switch to the other program by pressing the program button once, if you press and hold, you
can switch between the programs quickly.
• (U) When you want to see the welding output voltage, you can see the voltage unit by pressing the
MMA Mode;
button once. You can switch to the ampere unit by re-pressing the button and display the current
value (A) on the digital display.
The set welding current, parameter values and error codes can be monitored visually on the digital
9- Digital Display
display.
www.magmaweld.com
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Operation
27
EN