Table Des Matières; Safety Instructions - THERMOBILE AT 400 Manuel De L'utilisateur

All manuals and user guides at all-guides.com
Contents
English
Safety instructions....................................... 5
Introduction ................................................. 7
Preparations................................................ 8
Use............................................................ 10
Maintenance ..............................................11
Faults ........................................................ 14
Spare parts................................................ 17
Technical information ................................ 17
Installing accessories ................................ 17
Standards and guidelines.......................... 18
Preface
This manual contains instructions for use of
the stationary used oil fired heaters as shown
on the cover. The information in this manual
is important for the correct and safe use of
the heater.
Identification of the product (fig. 1)
The identification plate is attached to the side
of the heater. The identification plate contains
the following data:
A Year of manufacture
B Serial number
C Production code
D Voltage data
E Air displacement
F Capacity max (kW)
G Capacity max (MJ/h)
H Type of machine
Service and technical support
Please contact your dealer or the
manufacturer for information about the
heater. Make sure you have the following
data at hand: type and serial number of the
stationary used oil fired heater.
Warranty and liability
For warranty and liability, see general
warranty regulations.
AT 400 - 500-US series
Environment
Note
The heater is made of various metals
and synthetic materials. The heater
also contains electronic parts, which
must be treated as electronic waste.
Please contact your dealer for further
information.
1

SAFETY INSTRUCTIONS

1.1 Pictograms in this manual
Caution
Indicates risk of damage to the
appliance.
Warning
Indicates a dangerous situation, that
can lead to death or serious injuries.
Warning
Always switch off power when
performing maintenance or repairs on
the hot air heater!
Hot
Some surfaces may be hot! Wait until
these parts have sufficiently cooled
down before performing
maintenance.
Suggestions and tips to simplify the
carrying out of the specified tasks or
actions.
1.2 Pictograms on the stationary used
oil fired heater (fig. 2)
A Warning for quantity of oil to be used
Instruction not to put the burner dish on a
cold surface
B Overheating thermostat
C Instruction for re-ignition.
D Positions of the burner: low and high.
40.020.943 - rev. 04 - 2011
English
5