AMG 98 BASE 8 Mode D'emploi page 59

Problems and solutions
All repairs must be carried out exclusively by a specialised technician, with the
stove completely cold and the electric plug pulled out. Is prohibited from any un-
authorized modification to the device and the replacement of parts with other non-
original. The operations marked in bold type must be carried out by specialised
personnel.
Any inconvenience and solutions
Given that all stoves are tested in their parts handling and work and therefore are delivered in perfect
physical condition and operation, it should be remembered that the transport, unloading, handling, mis-
use or poor maintenance, can be causes of drawbacks.
The main problems may be solved by reading the table below.
If after doing as hereinafter described the problem is not resolved, contact your authorized service center.
PROBLEM
Display off and but-
tons are not work-
ing
Remote inefficient
Failure to ignite
the stove
Smoke comes from
the grill
Hot air fan is not
working
POSSIBLE CAUSE
1. Power failure in the net-
work
2. Switch back off
3. Display defective
4. Fault in the connection of
the display with the card
5. Fuse board interrupted
6. Card defective
1. Too far from the stove
2. No batteries in the remote
3. The remote control is
broken
1. Excessive accumulation of
ash in the grate
2. Incorrect ignition proce-
dure
1. Accidental electrical black-
out
1. The stove has not yet
been heated
REMEDY
1. Check that the power cord is connected
2. Use the switch back to operate it
3. Unplug the stove from the power outlet
for about one minute and then turn on. If
the problem persists, contact an authorized
service center
4. Check that the display and board are
properly connected. Contact your author-
ized service center
5. Contact an authorized service center
6. Contact an authorized service center
1. Move closer to the stove
2. Check and change the batteries
3. Replace the remote control
1. Clean the grate
2. Repeat the ignition procedure. If the
problem persists, contact your authorized
service center
1. In case of ignition phase interrupted and
momentary interruption of the fan, can occur
slight amount of smoke
1. Wait until the conclusion of the ignition cycle.
Arrived in temperature, the fan will start au-
tomatically. If the problem persists, contact
your authorized service center.
27