AMG 98 BASE 8 Mode D'emploi page 44

Stove start up
Remove any components which might burn from the firebox and from the glass
(various instructions and adhesive labels).
Charge pellet
Fuel is loaded from the upper part of the stove by opening a door. Pour the pellets in the hopper. This
is easier if performed in two steps:
• Pour half of the contents of the bag into the hopper and wait for the fuel to settle on the bottom.
• Then pour in the rest.
Never remove the protection grille in the hopper. When filling, do not let the sack
of pellets touch any hot surfaces.
The brazier should be cleaned before each starting.
First lighting of the stove
• Before switching on, make sure that the grate is clean and empty of any pellet residues from previous
combustions. Otherwise make sure you empty and clean it
• Fill the container 3/4 full with the pellets recommended by the manufacturer
• Connect the stove to an electrical outlet with the cable that has been supplied
• Press the lighting switch located on the back part of the stove
• The upper display will read " " O F F
• Press the button for 2 seconds. After a few moments the smoke extractor and the lighting resistor
will start and the display will read " " S T A R T
• After 1 minute the display will read " " L O A D P E L L E T
lighting the resistor
• Once the appropriate temperature has been reached the display will read " " F L A M E L I G H T
means that the stove has begun the last phase in lighting, at the end of which the stove will be
completely operational; The led resistence is switched off
• After some minutes the display will show the words " " W O R K
current working power. The stove is now completely on
• When the stove reaches the set temperature, the display will show " " M O D U L A T I O N
Before lighting a small amount of smoke may fill the combustion chamber.
We highly recommend to turn to our Authorized Service Centre for the
installation and the first ignition of the device as it not only carries out
the installation perfectly but also verifies the regular operation of it.
During the first lighting the environment should be well ventilated since during
the first hours of operation unpleasant odours could develop due to the physical
stabilizing of the paint and from the grease in the tube bundle.
12
O F F " "
S T A R T " " ; The led resistance is switched on
L O A D P E L L E T " " , the stove will load the pellets and continue
W O R K " " alternating room temperature and
M O D U L A T I O N " " .
F L A M E L I G H T " " : this