AMG 98 BASE 8 Mode D'emploi page 40

REMARKS:
- the appliance must be installed by a qualifi ed technician in possession of the technical and professional
requirements according to the DM37/2008 that, under its responsibility, to ensure compliance with the
rules of good technique.
- you need to keep in mind all laws and national, regional, provincial and municipal laws of the country
in which you installed the device
- check that the fl oor is not fl ammable: if necessary use a suitable platform
- in the room where the generator must be installed to heat must not pre-exist or be installed with an
extractor hood or ventilation ducts of the collective type.
Should these devices be located in adjacent rooms communicating with the installation, and 'prohibited
the simultaneous use of the heat generator, where there is a risk that one of the two rooms being
placed in depression than the other
- it is not permissible to install in bedrooms or bathrooms.
Remote Control
The remote control (Fig. 3) used to adjust water temperature
power and the on/off functions for the pellet stove.
To start the stove, press key and the stove will automatically
enter the starting phase.
Press keys + (1) and - (2) to adjust temperature, and use
keys + (6) and - (5) to adjust operating power.
To turn off the stove, hold down key .
To replace the 3 volt battery located on the back of the
remote control, pull the centre of the cover and the lever
on the side of the same, replace the battery observing the
correct polarity (Fig. 4)
Pellet
The pellets are cylinders of compressed wood, produced from sawdust and wood
processing (chips and sawdust), generally produced by sawmills and carpenters. The
binding capacity of the lignin contained in wood, allows to obtain a compact product
without adding additives and foreign chemicals to the wood, is therefore
obtained a natural fuel with high yield.
The use of expired pellets or any other unsuitable material can damage
parts of the thermostove and impair proper operation: this can lead
to the termination of the guarantee, and its producer responsibility.
For our products use pellets diameter 6 mm, length 30 mm and
a maximum of 8% and A1 certifi ed according to the UNI EN ISO 17225-2 standard. Keep the
pellets away from heat sources and not in humid environments or with explosive atmosphere.
8
Fig. 3 Fig. 3 Fig. 4