AMG 98 BASE 8 Mode D'emploi page 35

Charge pellet
Fuel is loaded from the upper part of the stove by
opening a door.
Pour the pellets in the hopper; vacuum contains
about 20 kg of pellets. This is easier if performed
in two steps:
• Pour half of the contents of the bag into the
hopper and wait for the fuel to settle on the
bottom.
• Then pour in the second half;
• Keep the cover closed , after loading the pellets
, the lid of the fuel tank;
• Before closing the door load-pellet make sure
that there are no residues of pellets around the
seal. If carefully cleaned to avoid compromising
the seals.
The stove is a product by heating, presents the ex-
ternal surfaces particularly hot. For this reason, we
recommend extreme caution when operating in
particular:
• Do not touch the stove body and the various
components, do not approach the door , it could
cause burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come near;
Never remove the protection grille
in the hopper. When filling, do not
let the sack of pellets touch any
hot surfaces.
In order to achieve the test report results, please load the performance parameters retained by
the manufacturer and the qualified tecnichian. They will use these parameters once verified
that, during the installation, it is possibile to reproduce the laboratory conditions.
With the door load-pellet open the stove does
not work.
If the door is left open for more than 120 sec-
onds the display will show "A L A R - D E P - F A I L
and the stove will shut down. Ensure that the
lid of the pellet is firmly closed (must push the
microswitch).
To ensure an airtight seal must be cleaned be-
fore the bar of the door seal pellet feed.
If this is not done cleaning the lid may not close
perfectly and the stove would go off as a result
of the error "A L A R - D E P - F A I L A L A R - D E P - F A I L ".
A L A R - D E P - F A I L "
3