Amann Girrbach PL900S Mode D'emploi page 34

I N S T A L L A T I O N
E N
Fig. 8 Marking of tool positions
The blank holders and tools are colour-
coded depending on application.
▷ Make sure to observe colour assignment
(e.g., orange tools to orange holder). Do
not mix differently colour-coded blank
holders and tools.
▷ Insert the standard tools into the blank holder.
Position the tool shank facing toward the out-
side.
▪ Cutter 1.8 is in the spindle.
▪ Set cutter 1.4 to position "2 A".
▪ Set cutter 1.0 to position "3 A".
▪ Set cutter 0.4 to position "4 A".
▷ Optionally: Insert the sister tools into the blank
holder. Position the tool shank facing toward
the outside.
▪ Set cutter 1.8 to position "1 B".
▪ Set cutter 1.4 to position "2 B".
▪ Set cutter 1.0 to position "3 B".
▪ Set cutter 0.4 to position "4 B".
34
▷ Insert the selected blank into the blank holder.
2.
Fig. 9 Inserting a blank
▷ Tighten the screws with the Allen key provided.
After re-positioning the milling machine, it
is necessary to check the system axes.
To check the axis system:
▷ With the door shut, select the
tion
function at the operational display.
▷ Follow the instructions on the display.
1.
Service/Calibra-