Thermal Protection - Sinmag Europe Creamco 30L Mode D'emploi

ATTENTION: Unplug the machine from the mains before maintenance works. Do
not perform any maintenance while the machine is in operation.Do not remove
any oil and grease or clean moving parts with bare hands.
ENG
The manufacturer is not liable for any damage to persons, animals or objects if this manual
is not followed or the shields and protective devices of the machine have been tampered
with and/or not properly used.
REDUCER MAINTENANCE
The worm drive gearing is filled with synthetic oil and is maintenance-free. Acceptable oils
for the reducer:
Oil Type
Synthetic -25 °C.
Amount of oil in the gearing: 0.08 l

THERMAL PROTECTION

The machine has a thermal switch to disconnect the heater power supply in case of
contactor damage.
If, despite proper heating (and proper signal lighting informing the heating is on), the oil
is not warming up, call a qualified electrician to check the cause of the machine damage.
Possible cause of this failure may be the contactor damage.
If the contactor is damaged in the "closed" position, the machine will continue to heat
the oil until the thermal switch under the rear cover is disconnected (Drawing. 1, pos.
9). Emergency self-disconnecting will occur when the oil temperature is about 190 ° C.
Disconnect the machine from the mains, remove the rear cover (9) of the heater and check
whether "thermal protection" is activated. This will occur when the pin pointed by arrow
shown in the image below is in projected position.
Once the machine is cooled down, it will be possible to press the pin. Thermal switch will
then be ready for further operation. It is necessary to find the cause of such breakdown and
then take action to eliminate it.
18
Ambient ISO
Temperature Identification
VG 320
±50 °C.
AGIP SHELL
Telium Tivela Oil
VSF320 SC320
IP MOBIL CASTROL
Telium Glygoyle Alphasyn
VSF 30 PG320