Stihl FCB-KM Notice D'emploi page 6

English
Before Starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the
KombiMotor and KombiTool instruction
manuals.
Blade correctly and securely
–
mounted and in good condition
(clean, move freely, not warped).
Inspect the deflectors for damage
–
and wear. Do not operate the
machine with a damaged deflector –
replace damaged parts.
Never attempt to modify the controls
–
or safety devices – work only with a
properly mounted deflector.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Adjust the harness and handle(s) to
–
suit your height and reach.
To reduce the risk of accidents, operate
your power tool only if it is in a safe
condition.
If you use a shoulder strap or full
harness: Practice removing and putting
down the machine as you would in an
emergency. To avoid damage, do not
throw the machine to the ground when
practicing.
Holding and Controlling the Power Tool
Make sure you always have good
balance and secure footing.
Always hold the power tool firmly with
both hands on the handles.
4
All manuals and user guides at all-guides.com
Models with loop handle
On models with a loop handle and
barrier bar, left hand on loop handle,
right hand on control handle, even if you
are left-handed.
Models with bike handle
Right handle on control handle, left hand
on left handle.
During Operation
In the event of impending danger or in
an emergency, switch off the engine
immediately by moving the slide control
/ stop switch / button to 0 or STOP.
15m (50ft)
The cutting attachment may catch and
fling objects a great distance and cause
injury - therefore, do not allow any other
persons within a radius of 15 meters of
your own position. To reduce the risk of
damage to property, also maintain this
distance from other objects (vehicles,
windows). Even maintaining a distance
of 15 meters or more cannot exclude the
potential danger.
To reduce the risk of
injury, avoid contact with
the blade.
The correct engine idle speed is
important to ensure that the blade stops
moving when you let go of the throttle
trigger. Check and correct the idle speed
setting regularly. If the cutting blade still
rotates when the engine is idling, have
your dealer check your machine and
make proper adjustments or repairs –
see KombiMotor instruction manual.
To reduce the risk
of injury from
thrown objects,
never operate the
unit without the
proper deflector for
the machine and
cutting attachment
being used.
The gearbox becomes
hot during operation. To
reduce the risk of burn
injury, do not touch the
gear housing.
Take special care in slippery conditions
(ice, wet ground, snow) – on slopes or
uneven ground.
FCB-KM