Allocation of CHANNEL 1 of remotes
Allocation of CHANNEL 2 of remotes
Allocation of CHANNEL 3 of remotes
Allocation of CHANNEL 4 of remotes
Selection of type of remotes
Selection type of operators
Selected work with or without encoders.
CAUTION: Remember to correctly set the jumpers J5 and J9 (see table 1)
WARNING: J5, J9 and P029 must be set correctly before performing the procedure for programming
Selectioning operators number
Operators speed adjustment during slow-down while opening
Operators speed adjustment during the stroke while opening
Operators speed adjustment during the stroke while closing
Operators speed adjustment during slow-down while closing
Slow down duration adjustment while opening
Slow down duration adjustment while closing
Operator 1 force adjustment while opening (if = 100% obstacle detection deactivated)
Operator n.1 force adjustment while closing (if = 100% obstacle detection deactivated)
Operator n.2 force adjustment while opening (if = 100% obstacle detection deactivated)
Operator n.2 force adjustment while closing (if = 100% obstacle detection deactivated)
Automatic closing times adjustment (if = 0 automatic closing deactivated)
Pedestrian automatic closing time adjustment (se = 0 pedestrian automatic closing deactivated)
Pedestrian stroke duration adjustment
Pre-flashing time adjustment
Adjustment of phase displacement time while opening
Adjustment of phase displacement time while closing
Collectivity function: if it is activated it deactivates both opening and closing inputs for the whole duration of
automatic opening and closing
44
Warning: the OPEN_PM and CLOSE_PM functions
are not available with the HCR Rolling Code set
(P027=1)