Dea NET24N Notice D'emploi Et Avertissements page 37

6 STANDARD PROGRAMMING
1 Power Supply
Give power supply, the display shows the following symbols "
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START command
is given, the position reset procedure is performed (see "rESP" in the table "WORKING STATUS MESSAGES" on page 52.
2 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the
screen reads P013;
2. Access the parameter by pressing the
3. The "Input Status" is shown on the screen (check that this
is correct):
4. Press the button again;
5. The "Total Operation Counter" is shown on the screen
(* see P064):
Ex: = 3x1000* = 3000 operations executed
6. Press the button again;
7. The "Maintenance Operation Counter" is shown on the
screen (* see P065):
Ex: = 5*x500 = 2500 operations still to be car-
ried out before the maintenance intervention request (
= maintenance operation counter disabled)
8. Press the button again to exit the parameters (P013 is
shown on the screen again).
3 Selection type of operators
1. Scroll down the parameters with
lise P028;
2. Access the parameter by pressing the
3. Acting on and keys, set:
Type 00 Type 01
• 005 5/24 • 000 Geko - An-
• 006 8/24 golo
• 007 Gulliver - Rev • 001 Look - Mac
• 002 Ghost
• 003 Livi 500 -
502 - 550PL
Warning: If you are using non DEA System operators, set the parame-
ter on the closer value for family type and performances (refer to table
on page 28).
4. Confirm your choice by pressing the
to P028).
", "
and keys until the
button;
! IMPORTANT !
and keys until you visua-
key;
Type 02 Type 03
• 003 Livi 902/24 - • 003 Pass
905/24 • 004 Stop
key (display returns again
", " " (or the Type selected) and then "- - - - ".
35