4 CONFIGURATION OF THE CONTROL PANEL
The universal control unit NET24N can be used for the management of the following types (
stem: swing and sliding gates, overhead doors and barriers.
In order to ensure maximum adaptability to each
first turn, for the optimal configuration of inputs, outputs and parameters (see diagram
in the mode "dedicated" to the
programming for the installation on which it is operating.
All settings remain in memory even in the case of subsequent flare-ups (see diagram
If necessary the
of configured closing can be later adjusted following diagram
FIRST CONTROL BOARD IGNITION
Configuration after the first ignition
For the first control panel ignition, proceed as fol-
lows:
1. Apply power, the display shows in sequence the
writing "
" and "
2. Press the
button and hold for 5 seconds until
the display shows
on the display;
3. Acting on the
and
keys, select the desired
configuration depending on the type of installa-
tion (es.
) and confirm by pressing the
button;
At this point, the selection will be stored and relo-
aded each time in the future.
4. Follow signs, "
", "
symbol of closed gate "- - - - ".
Following ignitions
If you have already saved a configuration, proce-
ed as follows:
Apply power, the display shows in sequence the
writing "
", "
", "
symbol of closed gate "- - - - ".
Modify the existing configuration
If you have already saved a configuration and you
want to change it, proceed as follows:
1. Hold down the
button and give power, the di-
splay shows in sequence the writing "
"
" flashing;
2. Press the
button and hold for 5 seconds until
the display shows
(the value changes to
match the previous configuration used) on the
display;
3. Acting on the
and
, select the new desired
configuration depending on the type of installa-
tion (es.
) and confirm by pressing the
button;
Stop the reconfiguration procedure prior
to confirmation, involves loading the previous
configuration by the control panel without any
modification.
However, if the reconfiguration procedure is
brought to an end, the new configuration will
take the place of the previous one and will be
reloaded each time in the future.
4. Follow signs, "
", "
symbol of closed gate "- - - - ".
of closure, the control board provides an initial procedure, performed only at the
of selected closing. After performing the initial configuration it is sufficient to execute the standard
" flashing;
" followed by the
" followed by the
" and
" followed by the
) of closures motorized by DEA Sy-
). Once configured, the control panel will operate
).
.
Sliding gates
Swing gates
Overhead doors
Barriers
29