Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 2.5
CAUTION! Do not sharpen a drill bit for more than 5 seconds. This will cause excessive heating
and may damage or melt the drill guide.
6.
Cool the drill bit in water for 5 minutes between each sharpening.
7.
Repeat the procedure for each cutting surface (most drill bits have 2 edges, although there
are exceptions).
8.
For excessively dull drill bits, it may be necessary to sharpen the bit multiple times to achieve
the desired level of sharpness.
9.
Lubricate the input shaft with a non-penetrating oil or lubricant after use.
MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to control and will
prevent unnecessary problems.
2.
Keep the tool handles clean, dry and free from oil/grease at all times.
3.
Follow instructions for lubricating and changing accessories.
4.
Inspect the tool fittings periodically. Have damaged or worn components repaired or replaced
by an authorized technician.
5.
Maintain the tool's label and name plate. These carry important information. If unreadable or
missing, contact Princess Auto Ltd. for replacements.
CAUTION! Only qualified service personnel should repair the tool.
LUBRICATION
Only use the lubricants supplied with the tool or specified by the manufacturer. Other lubricants may not
be suitable and may damage the tool or cause a malfunction during use.
CAUTION! NEVER use a penetrating oil to lubricate the tool. Penetrating oil may act as a solvent that
will break down the housing.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the steel parts to avoid rust.
Remove the lubricant before using the tool again.
DISPOSING OF TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate
recycling facility.
TROUBLE SHOOTING
If the tool does not function properly or if it is missing parts, contact Princess Auto Ltd. for a solution. If
unable to do so, have a qualified technician service the tool.
6
Drill Bit Sharpening Jig
For technical questions call: 1-800-665-8685
8089591
Publicité
Table des Matières
