Electrical Connection; Start Of Operation; Technical Data - bora CC 21 Instructions De Montage Et D'utilisation

Assembly instructions
6. Finally, fill the gap between the hob and the worktop with
silicone adhesive.
7. Smooth the joint with a spatula and water containing a little
washing-up liquid.
Attention: Use sealing tape! The silicone adhesive
not get under the support surface. If this occurs it will not be
possible to remove the hob again at a later stage. No liability will
be assumed in the case of failure to observe these instructions.

Electrical connection

• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to disconnect it from the
mains at all poles with a contact opening width of at least
3mm. Line-protecting switches, fuses or contactors are
suitable cut-out devices. When connecting and repairing the
appliance disconnect it from the electricity supply with one of
these devices.
• The earth wire must be sufficiently long so that if the strain
relief fails, the live wires of the connecting cable are subjected
to tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the
voltage on the rating label.
• The hob has been fitted with a temperature-resistant
connection cable in the factory.
• The connection cable must be at least H05 RR-F.
• If the excess cable of this appliance is damaged, it has to be
replaced by the manufacturer, the Customer Service of the
manufacturer or by another qualified person to avoid danger.
• Full protection against accidental contact must be ensured on
installation.
• Attention: Incorrect connection may result in the power
electronics unit being destroyed.
Power supply
Mains voltage: 220 - 240V~, 50-60 Hz
Component rated voltage: 220 - 240V

Start of operation

must
Once the hob has been installed and the power supply has been
provided (mains connected) an automatic test of the controls will
be carried out and information for Customer Service will be
indicated.
Important: No items may be on the touch control sensor keys
when the appliance is being connected!
Briefly wipe over the surface of the hob with a sponge and soapy
water and then dry with a clean cloth.

Technical data

Dimensions
Hob
Height/ width/ depth
Cooking zones
Back
Front
Hob, total kW
Dimensions
Hob
Height/ width/ depth
Cooking zone
Hob, total kW
mm 40 x 340 x 515
Ø cm (kW) 18/ 12 (1.7)
Ø cm (kW) 14.5 (1.2)
2.9
mm 40 x 340 x 515
cm 18.5 x 30.5
kW 1.4
1.4
GB
29