General Set Up - Shop-Vac SE Serie Manuel D'utilisation

12. Position the tank, in the upright
position, with the inlet facing you.
Put the support assemblies inside
the tank, then place the screws
through the holes provided on left
side of the tank. Make sure the
FIGURE 17
plastic portion is located inside the
tank. Turn the supports until the
back of the supports fit flush against the inside curve
of the tank. FIGURE 17.
13. Remove any webbing that
attaches the tank handles to each
other. Take the side tank handle
with the letter L and position it on
the outside of the tank where the
support assemblies are installed.
FIGURE 18
The U-shaped cutout on the bottom
end of the handle must face the rear of the tank. Secure
the handle to the tank with the screws in the support
assemblies. FIGURE 18.
14. Repeat steps 11 to 13 using right side of tank and
the remaining handle marked with the letter R.
15. Position metal carriage handle
outside of tank and under the tank
handles. Be sure to spread ends of
carriage handle when assembling
to prevent damage to tank. Line up
holes in ends of carriage handle with
FIGURE 19
holes in bottom of tank handles.
Make sure carriage handle is in the U-shaped cut on the
tank handles (located towards rear of unit). Secure with
1½" screws provided. FIGURE 19.
HOSE HOLDER
INSTALLATION
If not already installed, assemble as follows:
16. With rear of unit facing you, take
hose holder and position it with tabs
facing rear of unit.
FIGURE 20 .
FIGURE 20
17. Place "J" shaped tabs into the
slots on cord wraps. FIGURE 21.
Press down until tabs snap into
place.
FIGURE 21
PAGE 6
18. Press down on center of hose
holder until tab latches on bottom of
tank cover. FIGURE 22.
FIGURE 22

GENERAL SET UP

19. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
20. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
21. Insert machine hose end with locking-nut into inlet
of tank. Turn locking nut to tighten. Do not over-tighten.
FIGURE 23
23. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 23.
24. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your
local dealer or the Shop-Vac ® website.
Questions?
U.S. Customers call 888-822-4644
or visit www.shopvac.com 24 hours a day.
Canadian Customers call 905-335-9730
or visit www.shopvac.ca 24 hours a day.
22. Attach the extension wands
to the accessory end of the
hose. Twist slightly to tighten
the connection. FIGURE 23.