Unpacking; General Set Up - Shop-Vac SMK Serie Manuel D'utilisation

UNPACKING

Pull lid latches in an outward motion and remove tank cover. Remove any items that may have been packed in the vacuum tank.
TOOL HOLDER
Accessories will be shipped in the tool holder on the rear of the unit. Gently push down on top of holder and pull outward. FIGURE 1.
Tool holder can also be removed to carry with you. Tools can also be stored on the front cut outs on the dolly. FIGURE 2. and FIGURE 3.
FIGURE 1

GENERAL SET UP

1. Before replacing tank cover, refer to Dry Pick Up or Wet Pick Up Operation in user manual to ensure you have the proper
filters installed for your cleaning operation.
1a. Wand Clip Installation: Remove tank cover, slide tab of the clip into cut out on tank. FIGURE 4. Replace tank cover,
put wand into cut out on dolly and snap into the clip to hold wand in place. FIGURE 5.
FIGURE 4
2. Replace tank cover, and apply pressure with thumb to each latch until it snaps tightly into place. Make certain all lid latches are
clamped securely.
3. Insert machine hose end with locking-nut into inlet of tank. Turn locking nut to tighten. Do not over-tighten.
4. Attach the extension wands to the accessory end of the hose. Twist slightly to tighten the connection. FIGURE 6.
5. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands. Twist slightly to tighten
the connection. FIGURE 6.
NOTE: STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE RELATIVE
HUMIDITY OF THE AIR IS LOW. THIS IS ONLY TEMPORARY AND DOES NOT
AFFECT THE USE OF THE APPLIANCE. TO REDUCE THE FREQUENCY OF STATIC
SHOCKS IN YOUR HOME, THE BEST REMEDY IS TO ADD MOISTURE TO THE AIR
WITH A CONSOLE OR INSTALLED HUMIDIFIER.
Volts
120V
Ampere Rating
More Not More
Than Than
0 - 6
6 - 10
10 - 12
12 - 16
FIGURE 2
FIGURE 5
Total length of cord in feet
25 50 100
AWG
18 16 16
18 16 14
16 16 14
14 12 Not recommended
FIGURE 3
150
14
12
12
TABLE A
PAGE 5