Unpacking; Assembly; General Set Up - Shop-Vac SL14 Serie Manuel D'utilisation

UNPACKING

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.

ASSEMBLY

CASTER SYSTEM
ASSEMBLY
You will find four casters FIGURE
1 with your wet/dry vacuum.
Assemble as follows:
FIGURE 1
1. With cord disconnected from the receptacle and tank
cover removed, turn tank upside-down so bottom is
facing up.
2. If the casters are not already
installed in dolly, insert casters into
bottom of dolly by placing stem of
caster into holes provided. Apply
pressure and twisting motion until
casters snap into place. FIGURE
2.
FIGURE 2
3. Return tank to upright position.
SIDE TANK HANDLE
ASSEMBLY
You will find a handle pack
containing two side tank handles
FIGURE 3, four handle supports
FIGURE 4 and four screws.
FIGURE 3
FIGURE 4
Assemble as follows:
4. Take two handle supports and
two 1" screws. Place screws
through the hole provided in center
of each support. FIGURE 5.
FIGURE 5
5. Position the tank, in the upright
position, with the inlet facing you.
Put the support assemblies inside
the tank, then place the screws
through the holes provided on left
side of the tank. Make sure the
plastic portion is located inside
FIGURE 6
the tank. Turn the supports until
the back of the supports fit flush
against the inside curve of the tank. FIGURE 6.
6. Remove any webbing that
attaches the tank handles to each
other. Take the side tank handle
with the letter L and position it on
the outside of the tank where the
support assemblies are installed.
Secure the handle to the tank
FIGURE 7
with the screws in the support
assemblies. FIGURE 7.
7. Repeat steps 4 to 6 using right side of tank and the
remaining handle marked with the letter R.

GENERAL SET UP

8. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
9. Replace tank cover, and apply pressure with thumb to
each latch until it snaps tightly into place. Make certain
all lid latches are clamped securely.
10. Insert machine hose end into inlet of tank. Twist
slightly to tighten the connection.
FIGURE 8
12. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 8.
11. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 8.
PAGE 5