Set Up And Operation; Filter Installation And Maintenance - Shop-Vac 92 Serie Manuel D'utilisation

Masquer les pouces Voir aussi pour 92 Serie:

Mode d'emploi (46 pages)

Table Des Matières

Table des Matières

Les langues disponibles

DANGER

like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,

combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices

produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or

anywhere gasoline is stored or dispensed.

1. Refer to the filter installation and maintenance section to make sure the correct

filters are installed for your cleaning operation.

2. Replace tank cover, and apply pressure with thumb to each latch until it snaps tightly

into place. Make certain all lid latches are clamped securely.

3. Insert machine hose end with locking nut into inlet located in the front of the tank.

Turn locking nut to tighten. Do not over-tighten.

4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE:

Many more useful tools are available at your local dealer or the Shop-Vac

5. Plug the cord into the wall outlet. Your cleaner is ready for use.

I = ON, O = OFF

FILTER INSTALLATION AND MAINTENANCE

FILTRATION SYSTEM

There are a variety of filters available for your vacuum. There are cage filters that install onto the underside

of the tank cover and tank filters that install into the tank. The filters are grouped into three filtration

categories. General filtration is used for large debris; such as, wood chips, nails and gravel. Medium

filtration is used for medium debris; such as, dirt, sand and sawdust. Fine filtration is used for fine debris;

such as drywall dust, cold ash and cement dust. It is important to have the correct filters installed for your

cleaning operation to protect your vacuum motor. THE MOST EFFICIENT FILTRATION FOR YOUR VACUUM IS A

FINE FILTRATION CAGE FILTER WITH A FINE FILTRATION TANK FILTER.

NOTE: When using the vacuum to pick up very fine dust. It will be necessary to empty the tank and clean

the cage filter at more frequent intervals to maintain maximum pick up power or add a disposable filter bag.

DRY PICK UP OPERATION

NOTE: Never use the vacuum for dry pick up without a dry use filter installed. Using the vacuum without a

filter will cause dust to discharge from the blower port and cause damage to the motor.

WARNING

BEFORE REMOVING THE TANK COVER.

Follow the instructions for the filter that came with your vacuum. Some filters mentioned do not come

standard with all vacuums. Additional filters are available at your local dealer or the Shop-Vac

CARTRIDGE FILTER

The cartridge filter can be used for dry pick up and small quantities of wet pick up. Installation is the same

for both. When picking up fine dust or powders a high efficiency filter bag must be used with the cartridge

filter.

1. If a foam sleeve is installed on the lid cage, remove it by sliding it off the lid cage. NOTE: If the cartridge

filter has been used for wet pick up, it must be cleaned and dried before using it for dry pick up.

With the tank cover in an upside down position, slide the cartridge down over the lid

cage, pushing until the filter seals against the cover.