General Set Up; Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac SH Serie Mode D'emploi

15. Position the tank, in the upright
position, with the inlet facing you.
Put the support assemblies inside
the tank, then place the screws
through the holes provided on left
side of the tank. Make sure the
plastic portion is located inside
FIGURE 12
the tank. Turn the supports until
the back of the supports fit flush
against the inside curve of the tank. FIGURE 12.
16. Remove any webbing that
attaches the tank handles to each
other. Take the side tank handle
with the letter L and position it on
the outside of the tank where the
support assemblies are installed.
Secure the handle to the tank
FIGURE 13
with the screws in the support
assemblies. FIGURE 13.
17. Repeat steps 14 to 16 using right side of tank and
the remaining handle marked with the letter R.
TOOL HOLDER
ASSEMBLY
FIGURE 14
FIGURE 15
20. Press down on center of tool
holder until tab latches on bottom
of lid. FIGURE 16.
FIGURE 16
PAGE 6
18. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 14.
19. Place "J" shaped tabs into
the slots on cord wraps
FIGURE 15. Press down until
tabs snap into place.

GENERAL SET UP

21. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
22. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
23. Insert machine hose end into inlet of tank. Twist
slightly to tighten the connection.
FIGURE 17
25. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 17.
26. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your
local dealer or the Shop-Vac
Questions?
www.shopvac.com 24 hours a day.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without
a dry use filter installed on the lid cage. Using the
vacuum without a filter will cause dust to discharge
from blower port and cause damage to motor.
24. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 17.
website.
®