Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Coated screws
• Threadlocker
• Schorr washers
We recommend an additional protection against manipulation
by marking the fastening screws with locking varnish or sim-
ilar.
5 Commissioning and Operation
Risk of injury due to rotating shafts
Hair and loose clothing can be caught by rotating shafts.
• Prepare all work as follows:
ð Switch the operating voltage off and stop the drive shaft.
ð Cover the drive shaft if the operating voltage cannot be
switched off.
6 Maintenance
In harsh environments, we recommend regular inspections
for firm seating and possible damages at the device. Repair
or maintenance work requiring opening the device may only
be performed by the manufacturer.
In the event of questions or spare parts orders, please
provide us the data printed on the type plate of the device.
See chapter Contact [} 24].
22 | EN
DANGER
Prior to the work
• Switch off the power supply and secure it against switching
on again.
• Then disconnect the power supply lines physically.
• Remove operating and auxiliary materials and remaining
processing materials from the measuring system.
6.1 Cleaning the Measuring System
If the measuring wheel becomes soiled in adverse environ-
mental conditions, it can be cleaned according to the needs
with a detergent suitable for the material. Use a lint-free cloth.
6.2 Disassembly
To dismount the device, proceed in the reverse order of the
assembly, see chapter Installation [} 20].
6.3 Reassembly
Reassembling the device is only permitted under the follow-
ing conditions:
• The device is not damaged.
• The screws can be newly secured against loosening.
• All safety instructions of chapter Installation [} 20] can be
complied with.
• All assembly steps described in chapter Installation [} 20]
can be performed.
Operation Manual R60107.0009 - 01
Publicité
Table des Matières
