Black & Decker G915 Traduction Des Instructions Initiales page 9

Labels on tools
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Wear safety glasses or goggles
when using the tool.
Wear ear protection when using this
tool.
Electrical safety
This tool is double insulated;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the rating
plate.
• If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
Your tool has some or all of the following
features:
1. On/off switch
2. Side handle
3. Spindle lock
4. Guard
Assembly
Warning! Before assembly, make
sure that the tool is switched off
and unplugged.
Fitting and removing the guard
(fig. B & C)
The tool is supplied with a guard
intended for grinding purposes only. If
the unit is intended to perform cutting
off operations, a guard specific for this
operation must be fitted. A suitable guard
for cutting off operations part number
1004484-01 is available and can be
obtained from BLACK + DECKER service
centres.
Fitting
• Place the tool on a table, with the
spindle (5) facing up.
(Original instructions)
• Place the spring washer (6) over the
spindle and locate it on the shoulder
(7).
• Place the guard (4) onto the tool as
shown.
• Place the flange (8) over the spindle
with the protruding pips towards the
guard. Make sure that the holes in the
flange align with the screw holes.
• Secure the flange with the screws (9).
Make sure that the screws are fully tight
and that the guard can be rotated.
Removing
• Use a screwdriver to remove the screws
(9).
• Remove the flange (8), guard (4) and
spring washer (7). Store these parts
carefully.
Warning! Never use the
tool without the guard.
Fitting the side handle
• Screw the side handle (2) into one of
the mounting holes in the tool.
Warning! Always use the side
handle.
Fitting and removing grinding or cutting
discs (fig. D - F)
Always use the correct type of disc for
your application. Always use discs with
the correct diameter and bore size (see
technical data).
Fitting
• Fit the guard as described above.
• Place the inner flange (10) onto the
spindle (5) as shown (fig. D). Make sure
that the flange is correctly located on
the flat sides of the spindle.
• Place the disc (11) onto the spindle
(5) as shown (fig. D). If the disc has
a raised centre (12), make sure that the
raised centre faces the inner flange.
• Make sure that the disc locates
correctly on the inner flange.
ENGLISH
7
9