Black & Decker G915 Traduction Des Instructions Initiales page 11

• Firmly hold the tool with one hand
around the side handle and the other
hand around the main handle.
• When grinding, always maintain an
angle of approx. 15° between the
disc and the workpiece surface.
Maintenance
Your BLACK + DECKER tool has been
designed to operate over a long period
of time with a minimum of maintenance.
Continuous satisfactory operation
depends upon proper tool care and
regular cleaning.
Warning! Before performing any
maintenance on corded/cordless
power tools:
• Switch off and unplug the appliance/
tool.
• Or switch off and remove the
battery from the appliance/ tool if
the appliance/tool has a separate
battery pack.
• Or run the battery down completely if it
is integral and then switch off.
• Unplug the charger before cleaning
it. Your charger does not require
any maintenance apart from regular
cleaning.
• Regularly clean the ventilation slots in
your appliance/tool/charger using a
soft brush or dry cloth.
• Regularly clean the motor housing
using a damp cloth. Do not use any
abrasive or solvent-based
cleaner.
• Regularly open the chuck and tap it
to remove any dust from the interior
(when fitted).
(Original instructions)
TECHNICAL DATA
Voltage
Power input
No-load speed
Disc diameter
Disc bore
Max disc thickness
grinding discs
cutting discs
Spindle size
Weight
ENGLISH
G915
Vac 220 - 240
in (W) 900
min
-1 11000
mm 125
mm 22.2
mm 6
mm 3
mm M14
kg 2.1
11