Clean The Mopping Module - Dreame D9 Manuel D'utilisation

Routine Maintenance
EN

Clean the Mopping Module

1. Press the two release clips on the side of water tank, remove the mopping
module and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with water only and leave to air dry
before re-installing.
Note: Do not use any cleaning agents or disinfectants.
14
3. Clean the mop pad with water only and leave to air dry before re-installing.
Note:
•
Remove the pad from the mopping module before cleaning it, and make sure dirty
water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every 3 to 6
mouths.
4. If slow water flow occurs, or the volume is not well-distributed, please
clean the air hole in the cover of the water tank.
Routine Maintenance
Clean the Main Brush
Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
Pull out the brush covers as indicated by the diagram. Use the included
cleaning tool to remove any hairs tangled on the brush.
Clean the Side Brush
Pull out the side brushes and use the included cleaning tool to remove any hair
tangled on the brush.
Note: Do not pull out the hair excessively to avoid the damage of brush when the hair is
tightly tangled on the brush.
Clean the Main Wheel / Omnidirectional Wheel
Note: Use tools such as a small screwdriver, etc. to separate the axle and the tire.
EN
15