Preparation; Remove The Protective Film - Dreame D9 Manuel D'utilisation

Preparation

EN

1. Remove the protective film

Remove the protective films on the side of collision buffer and charging dock.
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
8
3. Place the charging dock on the level ground against wall
and connect to a power outlet
>0.5m
>0.5m
>1.5m
Note:
•
Make sure there is a distance of 0.5 meters or more on either side of the charging dock, and
more than 1.5 meters in front of it.
• Tidy up any loose cord which could accidentally move or unplug the charging dock.
•
To ensure you can well connect to the robot with your phone, make sure the robot and
charging dock are in the range of Wi-Fi.
•
Do not place the charging dock in an area with direct sunlight or where other objects could
block its signaling area, as this may hinder the robot from returning to the charging dock.
4. Place the robot onto the charging dock to recharge. The
robot will turn on automatically and charge
Battery Level Indicator
•
White: Battery level is more than 15%
•
Orange: Battery level is less than 15%
Note:
• Fully charge before first use.
•
Don't install the mopping module while charging. Ensure the charging is in a safe
environment to prevent floor damage caused by wet dishcloth.
Connecting with Mi Home/Xiaomi Home App
This product works with Mi Home/Xiaomi Home app *.
1. Download Mi Home/Xiaomi Home App
Scan the QR code to download and install the app. You will be directed to the
connection setup page if the app is installed already. Or search "Mi Home/
Xiaomi Home" in the App Store to download and install it.
2. Add Device
Open Mi Home / Xiaomi Home app, and tap " " on the upper right. Then tap
top right corner " " , scan the QR code, add "Dreame Robot Vacuum D9" and
follow prompts to finish the connection.
xxxxxxx' home
No home environment info
Scanning for devices nearby...
What should I do if I cannot scan for
Devices Rooms
devices?
Note:
• Only 2.4GHz Wi-Fi is supported.
•
The version of the app might have been updated. please follow the instructions based on
the current app version.
3. Reset Wi-Fi
Simultaneously press and hold the buttons and until you hear a voice
saying "Waiting for the network configuration". Once the Wi-Fi indicator is
slowly blinking, the Wi-Fi has been successfully reset.
Wi-Fi Indicator
• Blinking slowly: To be
connected
• Blinking quickly:
Connecting
• On: Wi-Fi connected
Note: When your phone does not connect to the robot successfully, reset the Wi-Fi
and add the device again.
EN
9