Black 1-9/16" Flat Head Screw - Sauder 409048 Instructions D'installation

Step 17
1
D12
Groove
Insert the DRAWER SIDES (D12 andD13) at an angle
å
into the slot at each end of the DRAWER FRONT (M).
3
Fasten the DRAWER BACK (D62) to the DRAWER SIDES (D12 and D13). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D701) inserts into the groove of the DRAWER BACK (D62).
å
Page 22
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D13
M
D62
D12
D701
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D701
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D701) into the grooves in the
å
DRAWER SIDES (D12 and D13) and DRAWER FRONT (M).
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

(4 used in this step)
D13
409048
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
fi n
i s h
r f a
e d
c e
M
D13
30S
www.sauder.com/services