Black 1-9/16" Flat Head Screw - Sauder Utility Stand 409944 Instructions D'assemblage

Step 10
The tabs should insert freely into the
1
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D14
Groove
Insert the DRAWER SIDES (D14 and D15)
å
at an angle into the slot at each end of the
DRAWER FRONT (J2).
3
KK
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (KK) to the DRAWER
å
FRONT (J2). Tighten one HIDDEN CAM.
www.sauder.com/services
D15
J2
Maximum
Arrow
210 degrees
Minimum
190 degrees
J2
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D14
J2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D985) into the
å
grooves in the DRAWER SIDES (D14 and D15) and
DRAWER FRONT (J2).
4
Start each screw a few turns before

BLACK 1-9/16" FLAT HEAD SCREW

D14
KK
Fasten the DRAWER BACK (D61) to the DRAWER
å
SIDES (D14 and D15) and DRAWER BRACE (KK). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
409944
D985
D15
completely tightening any of them.
30S
(5 used in this step)
D61
D15
Page 15