Sauder 409048 Instructions D'installation page 17

Step 12
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (H) and lay it over your unit.
Make equal margins along all four edges of the BACK (H). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (H) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(42 used in this step)
These holes must line up over
the UPRIGHTS (C and D).
H
409048
1N
NAIL
Page 17