Sauder 409048 Instructions D'installation page 25

Step 20
To insert the drawer into your unit, tip the front of the drawer down and drop the rollers on the drawer behind the rollers on
å
the unit. Lift the front of the drawer up and slide it into the unit.
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the ENDS (A and B) and UPRIGHTS (C and D). Set the ADJUSTABLE SHELVES (J) onto the METAL PINS.
Insert the GROMMET (10P) and GROMMET CAP (1P) into the large hole in the TOP (E2).
å
Apply the WARNING LABEL (3L) to the TOP (E2). You should be able to read the label when the TV is removed from the
å
unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
1R
(20 used)
2R
www.sauder.com/services
95 lbs.
J
B
25 lbs.
J
J
25 lbs.
D
15 lbs.
1P
10P
3L
E2
25 lbs.
30 lbs.
J
C
25 lbs.
J
25 lbs.
50 lbs. total
409048
WARNING
Never use this furniture with a TV that is too
large or too heavy. Severe injury or death can
occur. The TV and furniture will be unstable
and may tip.
- The TV must weigh less than 95 lbs.
- The base of the TV must be able to sit
completely on this shelf.
A
Page 25