Black 1-9/16" Flat Head Screw - Sauder Harbor View 401685 Mode D'emploi

Step 15
1
D28
M
Groove
Insert the DRAWER SIDES (D28 and D29) at an angle
å
into the slot at each end of the DRAWER FRONT (M).
3
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D28 and D29).
å
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D707 ) inserts into the groove of
å
the DRAWER BACK (D78).
Repeat this step for the small drawer.
å
Page 20
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D78
D28
D707
D29
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
r f a
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D707) into the grooves in the
å
DRAWER SIDES (D28 and D29) and DRAWER FRONT (M).
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

401685
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
e d
c e
D707
D28
D29
M
30S
(8 used in this step)
www.sauder.com/services