Operation - SCHOLTES Hotte Manuel D'utilisation

3. Insert Ø10mm wall plugs into the holes drilled as A, B, C, and D and screw down the
screws at the points A + B, in such a way as to remain 5mm space between the screw head
and the wall (Fig. 5).
4. Hang it on the wall with the hanging plate of the cooker hood.
5. Tighten A + B (2) fixing screw on the wall, and completely secure the product from its
points D and C (Fig.5).
Assembly of flue adapter (Fig. 6)
Note : This section is for models that don't feature self flue exhaust.
1. Mount the plastic flue to the product body using 2 3.5x9.5 screws (Fig. 6).
2. Connect the flue adapter to the plastic flue when required (Fig. 6).
3. Mount the air outlet pipe of the product if necessary.
Assembly of sheet metal flues (fig.7)
Note : The outer and inner sheet metal flues are assembled one within the other (Fig. 7).
1. The cooker hood is set in the midst, and then the flue connecting plate (3) is directly fixed
to the wall, under the cover or points E and F are marked after performing a measurement.
2. Drill points E and F with Ø6mm drill bit, and insert Ø6mm and plastic dowels.
Insert the flue connection plate with 3.9x22 screws.
3. Inner Flue use 1 screw to 2 pull upper left and screw onto the flue connection plate
(3) from left and right (Fig. 7).
4. Fix the inner flue to the flue connection plate (2) with screws (3) (Fig. 7).
5. Fix the outer funnel to the product body from its lower section using 2 screws (4).

3. OPERATION

Your hood has 3 speeds.
Control panel
1 2
1. On/Off touch : to switch on and off the hood
2. Decrease speed
3. Display
4. Increase speed
5. Delay stop : You can program your hood extinction by pressing on the touch timer.
When timer button is pressed, a 15-minute timer function will be activated; display will give a
signal once the timer starts and the motor will switch off automatically after 15 minutes.
6. Light touch : to switch on and off the light.
3 4 5
29
6