Operation; External Exhausting Version; Operation With Recirculated Air - SCHOLTES HLI 997 Instructions Pour L'installation Et L'emploi

Operation

! It is strongly recommended that someone be in
attendance at all times when frying foods under the
hood.
! Food must not be flambéed under the hood because
of fire risk.
! For optimal evacuation of cooking smells, it is
recommended that the hood be turned on before
cooking begins. Similarly Leave the hood on for
another 10 to 15 minutes after cooking has finished.
The best performance of the unit is obtained in the
external exhausting version, therefore use this version
whenever possible.

External exhausting version

valve. In order to ensure that the ventilation unit
operates noiselessly, we recommend that a perfectly
smooth metal pipe be used.

Operation with recirculated air

With this version, the
grease vapours and
cooking fumes are
vented to the outside
through a special tube
(Ø 150 mm) connected
to the coupling ring B
(Fig. 10).
! Be careful when
tightening the collar to
fasten the pipe to the
coupling ring so as not
to block the nonreturn
One active charcoal filter
is needed for this and
can be obtained from
your retailer. The filter
removes the grease and
smells from the
extracted air before
sending it back into the
room through the upper
outlet grid.
The active charcoal filter
is washable (for further
informations read the
paragraph "Cleaning -
Cleaning the charcoal
filter"). It is essential that the filter be replaced once
every three years, or whenever the fibres become
damaged.
Mounting and replacing the active
charcoal filter
•
Disconnect the hood from the power outlet.
•
First remove the perimeter suction panels (f1).
•
Remove the metal grease filters. Remove the metal
grease filters using the handles designed for this
purpose by pulling the filter backwards and then
downwards. (f2-f3).
•
Remove the filter holder frame "h" by turning the
knobs "g" 90° that affix it to the cooker hood. Fig.
12.
•
Insert the sponge "i" of activated carbon into the
frame "h" and fit the whole back into its housing
"j".
•
Mount the filters and the perimeter suction panels
again.
GB
19