Maintenance; Cleaning The Outer Surface; Cleaning The Grease Filters; Charcoal Filters Replacement - SCHOLTES Hotte Manuel D'utilisation

4. MAINTENANCE

4.1 Cleaning the outer surface

The surface could be damaged due to aggressive and abrasive cleaning agents. Never use
aggressive and abrasive cleaning agents.. To clean the outer surfaces on your hood, use
soapy water and do not use scouring creams or scouring sponges.

4.2 Cleaning the grease filters

Filters should be cleaned when «C» signal appears on the Display or (due to usage) every 2
or 3 weeks. To delete «C» signal after the filters are cleaned and replaced, press and hold
button more than 3 secs (when device is off). Letter «E» will appear on the display and
it will switch to normal operation. If operation before deleting the «C» signal is required,
active motor speed will appear for 1 sec when you press
will resume running.
Use a brush, warm water and a mild detergent. Rinse and dry them carefully before putting
back in place. The grease filters can be placed in the dishwasher : Insert them in the
dishwasher without tightening them or in an upright position .
Note : In case of washing in dishwasher, a slight change might occur in color. This has no
effect on the function of the metal grease filter.

4.3 Charcoal filters replacement

This filter holds odours; it should be replaced after approximately 120 hours of use. It is
available from your dealer or after sales service.
1. Carbon filter
2. Carbon filter tab
3. Aluminium filter
4. Carbon filter tooth slot
Insert the carbon filter tooth located on the carbon filter into the carbon filter tooth
slot located on the aluminium filter and push forward to lock it.
Reverse the process to desinstall the carbon filter.

4.4 Replacing the lamps

Disconnect the electrical supply of the hood. Leave the lamps to cool down first because
they could burn your hands when they are hot. Max 50W it indicates the maximum power
consumption of the lamp. A lamp with same power rating should be used when replacing
the lamp.
Note : Only self-protection tungsten halogen lamp or self-protection metal halide lamp
must be used.
button and then the motor
30