Selco Genesis 4000 PME Manuel D'instructions page 50

E29 Incompatible measurements alarm
E30 Communication alarm (HF)
E38 Undervoltage alarm
E39, E40 System power supply alarm
E43 Coolant shortage alarm
E48 Wire out alarm
E49 Emergency switch alarm
E50 Wire stuck alarm
E51 Unsupported settings alarm
E52 Anti-collision alarm
E53 External flow switch alarm
E99 General alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
E56 Voltage level exceeded (Alarm)
E64 Voltage level exceeded (Warning)
E57 Voltage level exceeded (Alarm)
E65 Voltage level exceeded (Warning)
E60 Speed limit exceeded
50
(Alarm)
E68 Speed limit exceeded
E61 Speed limit exceeded
E69 Speed limit exceeded
E70 Incompatible "WARNING" alarm
E71 Liquid coolant overtemperature alarm
3.14 Rear panel
1 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.
2 Signal cable (CAN-BUS) input (RC)
3 Signal cable (CAN-BUS) input (Cable bundle)
4 Gas fitting (TIG)
5 Power supply cable
Connects the system to the mains.
(Warning)
(Alarm)
(Warning)