Replacement Parts - Metabo EC 1315S Manuel D'utilisation Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

37. RELEASE THE PRESSURE WITHIN THE SYSTEM
SLOWLY.
Dust and debris may be harmful.
38. KEEP THE EXTERIOR OF THE AIR COMPRESSOR
DRY, CLEAN, AND FREE FROM OIL AND GREASE.
Always use a clean cloth when cleaning. Never use
brake fl uids, gasoline, petroleum-based products,
or any strong solvents to clean the unit. Following
this rule will reduce the risk of deterioration of the
enclosure plastic.
39. IF CONNECTED TO A CIRCUIT PROTECTED BY
FUSES, use time-delay fuses with this product.
40. MAKE
SURE
THE
OBSTRUCTIONS OR SNAGS.
Entangled or snarled hoses can cause loss of balance
or footing and may become damaged.
41. NEVER LEAVE A COMPRESSOR UNATTENDED
WITH THE AIR HOSE ATTACHED.
42. DO NOT OPERATE THIS COMPRESSOR IF IT
DOES NOT CONTAIN A LEGIBLE WARNING
LABEL.
43. DO NOT CONTINUE TO USE A COMPRESSOR
OR HOSE THAT LEAKS AIR OR DOES NOT
FUNCTION PROPERLY.
44. ALWAYS DISCONNECT THE AIR SUPPLY
AND
POWER
SUPPLY BEFORE
ADJUSTMENTS, SERVICING A COMPRESSOR,
OR WHEN A COMPRESSOR IS NOT IN USE.
WARNING:
Repairs should be conducted only by a metabo HPT authorized service center.
HOSE
IS
FREE
OF
MAKING
The operation of any compressor can result in foreign objects being thrown into
your eyes, which can result in severe eye damage. Before beginning compressor
operation, always wear safety goggles, safety glasses with side shields, or a
full face shield when needed. We recommend Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with side shields. Always use eye
protection which is marked to comply with ANSI Z87.1.

REPLACEMENT PARTS

When servicing use only identical replacement parts.
45. DO NOT ATTEMPT TO PULL OR CARRY THE AIR
COMPRESSOR BY THE HOSE.
46. YOUR TOOL MAY REQUIRE MORE AIR
CONSUMPTION THAN THIS AIR COMPRESSOR
IS CAPABLE OF PROVIDING.
47. INSPECT COMPRESSOR CORDS AND HOSES
PERIODICALLY AND, IF DAMAGED, HAVE
REPAIRED AT YOUR NEAREST AUTHORIZED
SERVICE CENTER. CONSTANTLY STAY AWARE
OF CORD LOCATION.
Following this rule will reduce the risk of electric shock
or fi re.
48. NEVER USE AN ELECTRICAL ADAPTOR WITH
THIS GROUNDED PLUG.
49. CHECK DAMAGED PARTS. BEFORE FURTHER
USE OF THE AIR COMPRESSOR OR AIR TOOL,
A GUARD OR OTHER PART THAT IS DAMAGED
SHOULD
BE
CAREFULLY
DETERMINE THAT IT WILL OPERATE PROPERLY
AND PERFORM ITS INTENDED FUNCTION.
CHECK FOR ALIGNMENT OF MOVING PARTS,
BINDING OF MOVING PARTS, BREAKAGE
OF PARTS, MOUNTING, AND ANY OTHER
CONDITIONS
THAT
OPERATION. A GUARD OR OTHER PART THAT
IS DAMAGED SHOULD BE PROPERLY REPAIRED
OR REPLACED BY AN AUTHORIZED SERVICE
CENTER.
Following this rule will reduce the risk of shock, fi re or
serious injury.
English
CHECKED
TO
MAY
AFFECT
ITS
7

Publicité

Table des Matières
loading

Table des Matières