Applications; Checking The Safety Valve; Using The Air Compressor - Metabo EC 1315S Manuel D'utilisation Et Consignes De Sécurité

English

APPLICATIONS

Air compressors are utilized in a variety of air system
applications.
Match hoses, connectors, air tools, and accessories to the
capabilities of the air compressor.
You may use this compressor for purposes listed below:
○ Always use a minimum 3/8" (9.5 mm) or greater air
hose rated at 300 psi.
○ Operating air powered tools requiring less than
5 SCFM @ 90 PSI.
○ Powering pneumatic nail guns, infl ating tires,
cleaning / blowing with pressurized air.
WARNING:
Risk of Bursting. Too much air
pressure causes a hazardous
risk of bursting. Check the
manufacturer's
pressure
tools and accessories. The
regulator outlet pressure must
never exceed the maximum
pressure rating.
WARNING:
Do not allow familiarity with
compressor and tools to make
you careless. Remember that
a careless fraction of a second
is suffi cient to infl ict serious
injury.
WARNING:
Always wear safety goggles
or safety glasses with side
shields
compressor. Failure to do
so could result in objects
being thrown into your eyes
resulting in possible serious
injury.
CAUTION: Do not use in an environment that is
dusty or otherwise contaminated.
Using the air compressor in this
type of environment may cause
damage to the unit.
14
OPERATION (CONTINUED)
maximum
rating for air
when operating

CHECKING THE SAFETY VALVE

Before starting compressor, pull the ring on the safety
valve to make sure that the safety valve operates smoothly.
(Fig. 8) Do not use compressor if the safety valve is stuck
or does not operate smoothly. Have defective safety valve
replaced by a metabo HPT authorized service center.
WARNING:
Drain tank to release air
pressure before pull the ring
on the safety valve.
WARNING:
Risk of bursting.

USING THE AIR COMPRESSOR

○ Temperature
Operating temperatures are between 32°F and 104°F
(0°C and 40°C).
:
CAUTION Never operate in temperatures
below 32°F (0°C) or above 104°F
(40°C).
If the safety valve does
not work properly, over-
pressurization may occur,
causing air tank rupture or an
explosion.
Safety valve
Fig. 8