Metabo EC 1315S Manuel D'utilisation Et Consignes De Sécurité page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Always ensure the ON/OFF
switch is in the OFF (O)
position and the regulator
pressure gauge reads zero
before changing air tools or
disconnecting the hose from
the air outlet. Failure to do
so could result in possible
serious personal injury.
○ Ensure the compressor is positioned as shown and
that the telescopic handle is not extended. (Fig. 9)
:
CAUTION
Do
compressor set in the vertical
position.
Vertical position is used only when
storing the compressor.
○ Ensure the tank drain valve is closed (Fig. 10).
○ Ensure the ON/OFF switch is in the OFF (O) position
and the air compressor is unplugged (Fig. 10).
○ Ensure the pressure regulator knob is turned fully
counterclockwise (Fig. 10).
Drain valve
(closed)
Grounding
120 V
grounded
pin
outlet
Fig. 9
not
operate
with
Pressure
regulator knob
On/Off
switch
Fig. 10
○ If not already installed, attach the hose to the
compressor.
○ Always use a minimum 3/8" (9.5 mm) or greater air
hose rated at 300 psi.
○ Connect the air powered tools to the air hose by
inserting the male quick-connect plug to the quick-
coupler at the end of the hose (Fig. 11).
Pneumatic tool
(not included)
Air hose with quick
coupler fi tting
(not included)
○ Connect the power cord to the power supply.
the
NOTE: If compressor is connected to a circuit protected
by fuse, use time delay fuses.
Time delay fuses should be marked "D" in Canada
and "T" in the U.S.
○ Turn the ON/OFF switch to the ON ( I ) position.
○ Rotate the pressure regulator knob to the desired
line pressure. Pull the knob out and turn clockwise to
increase pressure and counterclockwise to decrease
pressure. When the desired pressure is reached push
knob in to lock in place.
NOTE: Before connecting or disconnecting air tools, turn
the regulator knob counterclockwise to stop the
fl ow of air.
○ Following all safety precautions in this manual and the
manufacturer's instructions in the air tool manual, you
may now use your air-powered tool.
○ If using an infl ation accessory with a quick-connect
fi tting, control the amount of air fl ow with the
pressure regulator knob. Turning the knob fully
counterclockwise will completely stop the fl ow of air.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher
pressure than needed will drain air from the tank
more rapidly and cause the unit to cycle on more
frequently.
English
Male quick-
connect plug
Fig. 11
15

Publicité

Table des Matières
loading

Table des Matières