General Maintenance - Metabo EC 1315S Manuel D'utilisation Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
When servicing, use only
identical replacement parts.
Use of any other parts may
create a hazard or cause
product damage.
WARNING:
Always wear safety goggles
or safety glasses with side
shields during compressor
operation or when blowing
dust. If operation is dusty,
also wear a dust mask.
WARNING:
Always release all pressure,
disconnect
supply, and allow unit to cool
to the touch before cleaning
or making repairs on the air
compressor.

GENERAL MAINTENANCE

Humidity in the air causes condensation to form in the
air tank. This condensation should be drained daily and/
or every hour, using the instructions found in Draining the
Tank.
The safety valve automatically releases air if the air
receiver pressure exceeds the preset maximum. Check
the safety valve before each use following the instructions
found in Checking the Safety Valve.
Inspect the tank yearly for rust, pin holes, or other
imperfections that could cause it to become unsafe.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake
fl uids, gasoline, petroleum-
based products, penetrating
oils, etc., come in contact with
plastic parts.
Chemicals
weaken or destroy plastic
which may result in serious
personal injury
MAINTENANCE
LUBRICATION
All the bearings in this compressor are lubricated with
a suffi cient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication of the bearings is required.
SERVICE AND REPAIRS
All quality compressors will eventually require servicing
or replacement of parts because of wear and tear from
normal use. To assure that only genuine replacement parts
will be used, all service and repairs must be performed by
a metabo HPT AUTHORIZED SERVICE CENTER, only.
NOTE: Specifi cations are subject to change without any
from
power
can
damage,
obligation on the part of the metabo HPT.
English
17

Publicité

Table des Matières
loading

Table des Matières