Tools Required - R&G CP0298BL Instructions De Montage

ITEM10= M10x1.25x70mm LONG HEX HEADED FRAME BOLT LEFT HAND SIDE (x1).
ITEM 11= M8x1.25x20mm LONG CAP HEADED SPANNING BAR BOLTS (x2).
ITEM 12= M8 PLAIN WASHERS (x2).
ITEM 13= CRASH PROTECTOR (B0061 WITH CS340) (x2).
ITEM 14= M10x1.25x65mm LONG HEX HEADED FRAME BOLT RIGHT HAND SIDE (x1).
ITEM 15= LEFT HAND SIDE WELDED ASSEMBLY (M0287) (x1).
ITEM 16= SPANNING BAR (EB061) (x1)
Please note that in cases where kits are packed with rubber washers holding the components
onto the bolt – the rubber washers should be thrown away!

TOOLS REQUIRED


Socket set to include 17 and 19mm socket and wrench.

Set of metric Allen keys to include 4, 5, 6 and 8mm A/F sizes.

Socket set to include 10mm A/F socket and wrench.

Flat bladed driver.

Torque wrench (up to 40Nm).
TOWARDS REAR TOWARDS
FRONT
OF BIKE OF
BIKE
PICTURE 3
4 5
PICTURE PICTURE
R&G Racing
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com