American Standard EDGEWATER 4932.300 Instructions D'installation page 2

2
MAKE WATER SUPPLY CONNECTIONS
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall
supplies. Connection on fitting supplies are 3/8"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
* Faucet supplies are 21" long from faucet base.
• Note: If additional supply length is required, installer
must purchase additional parts separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
3
CONNECT SPRAY HOSE & INSTALL WEIGHTS
• Push the SPRAY HOSE END (2) into the HOSE CONNECTOR
(1) slide down LOCKING COLLAR (3) until it snaps into place
to secure connection.
• With HAND SPRAY (4) seated in SPOUT (5), install
WEIGHT (6) at labeled area onto HOSE (7), secure
with SCREWS (8).
4
CHECK CONNECTIONS FOR LEAKS
• Move HANDLE into "off" position.
• Turn on water supplies and check connections for leaks.
• Operate HANDLE (1) up and down, left and right to
flushwater lines thoroughly.
• Operate HAND SPRAY and check connections for leaks.
CHECK CONNECTIONS
FOR LEAKS
R E D
S T R I P E
5
4
(610 mm)
8
6
7
- 2 -
B L U E
S T R I P E
2
1 COLD
HOT
2
21"
1
8
M965717 Rev. 1.8 (5/21)
3