Use; Manually Adjustable Sections; Electrically Adjustable Sections - Auping Royal 300 Mode D'emploi

4. Use

4.1 Manually adjustable
sections*
Head support
The head support has two adjustable
positions. Pull gently on the handle
until the desired position is reached.
To put the head support into a lower
position you must first pull it up as
far as it will go and then lower it
again.
Back section
The back section has eight positions.
Pull gently on the handle until the
desired adjustment is reached. You
can set the back section to a lower
position by first pulling the section
up completely, and then lowering it
gently.
Foot section
The foot section has one elevated
adjustment position. Pull gently on
the handle until the foot lift is in
position. You can reset the foot lift to
the horizontal position by first pulling
it upward, and then lowering it
gently.
Always use the handles when
adjusting the manually adjustable
parts.
The knee lift can only be adjusted
electrically and not manually.
* If applicable
4.2 Electrically adjustable
sections
1. Memory buttons
2. Raise head support
3. Lower head support
4. Raise back section
5. Lower back section
6. Raise knee section
7. Lower knee section
8. Raise foot lift
9. Lower foot lift
10. Release buttons
11. Programming and child-lock
button
The remote control is used to adjust
the motorised sections of your bed.
To comply with "GS" safety
regulations, the remote control must
always be operated using two hands.
This prevents one hand getting
trapped between the moving parts
while adjusting.
To use any of the adjustment or
programming functions, always keep
one of the blue release buttons
pressed down. Use the fingers of
your other hand to operate the up or
down or memory buttons. The
remote control has a memory, in
which you can store three pre-set
positions, and a childproof function
with which you can lock the
adjustment functions.
GB9