Auping Royal 300 Mode D'emploi page 34

Calling up the pre-set position
(fig. 3)*
1.Press a release button and keep it
pressed.
2.Press the desired memory button
using the other hand. Keep both
buttons pressed until the motors
have stopped.
The mesh base is now in the pre-
programmed position.
Switching on the childproof
function (fig. 4)*
1. Press a release button and keep it
pressed.
2. Press the programming button
and keep it pressed down for at
least ten seconds until your hear a
high-pitched beep.
If you try to adjust the bed while the
childproof function is in operation,
you will hear a double beep.
Switching off the childproof
function (fig. 5)*
1. Press a release button and keep it
pressed.
2. Press the programming button
and keep it pressed down for at
least ten seconds until your hear a
high-pitched beep.
The childproof function is now
switched off.
* If applicable
1 2
1 2
1 2
fig. 3
fig. 4
fig. 5
GB11