Preparing For Use; Components Of Your Mesh Base; Position Of The Legs; Fitting The Mattress - Auping AVS 433 Mode D'emploi

3. Preparing for use

3.1 Components of your mesh base

- Auping AVS mesh base.
Your supplier will install your AVS mesh base
for you.
For other parts and detailed installa tion
instructions, we refer you to the installation
cards included with the various parts.

3.2 Position of the legs

It is vitally important that the feet be fitted
properly, to ensure the appropriate distribution
of weight. This means that the legs must be
placed at the distances from head and foot
end of the bed as indicated in the following
illustration (bed seen from above):
Length 190/200 cm: H 20 cm
Length 210/220 cm: H 30 cm
GB14
_01G4Q_3392 AVS 433 bw.pdf - pag.14
Head (H)
Foot (F)
F 20 cm
F 30 cm
LET OP !!! Lage resolutie!

3.3 Fitting the mattress

Put your bed in the horizontal position.
Make sure that the five protruding clip-on pins
of the mattress connectors are pushed width-
ways into the mesh (see fig. 2).
'Click' the mattress connectors into the mesh at
the positions indicated (see fig. 2).
Make sure that the mattress connectors are
not directly above a cross bar.
Put the mattress on the mesh base and
centre it.
fig. 2
June 3, 2008