Technical Specifications - Rocal Angle Manuel Des Caracteristiques, Installation Et Fonctionnement

1. SPECIFICATIONS

1.1 Technical specifications

Parameter
Minimum - Maximum draught
Fuel consumption
Smoke mass flow rate
Performance
Nominal output
Power range
Average CO concentration at 13% of O
NO concentration at 13% of O
x
OGC concentration at 13% of O
Particle concentration at 13% of O
Medium draft (trial)
Net weight
Maximum authorized load (fuel)
Reload height
Logs length
Minimum flue height
Flue duct
Ø Air inlet
Front safety distance
Side safety distance
Back safety distance
Average temperature of smoke
Type of combustion
Flue liner
Fuel
Humidity fuel logs
Certification year
Certificate No.:
1.2 Breakdown of delivery components
(
Make sure you have all the components described below in relation to the picture on section II of the ANNEXED document)
1. Fireplace's body.
2. Flue liner connector.
3. Aluminium ring to connect external air, exterior air inlet cover, metal clamp, 8x screws and 4x washers.
4. Ceiling plate, 3x anchors and 3x screws.
5. Heat-resistant spray paint for touch-ups.
6. Documentation bag: output declaration, energy label, guarantee, technical sheet, and installation and operating
characteristics manual.
7. Bag with: 6x metal acnhors, 6x screws, 6x washers and 6x nuts and adhesive ceramic rope.
8. Cleaning cloth.
9. Heat-resistant glove.
1.3 Diagram of the equipment's measurements
See the ANNEXED document, section I
2. REQUIREMENTS PRIOR TO INSTALLATION
ALL LOCAL STANDARDS, INCLUDING NATIONAL AND EUROPEAN REGULATIONS MUST BE COMPLIED WITH UPON
INSTALLATION OF THE EQUIPMENT.
THE INSTALLATION MUST BE PERFORMED BY A PROFESSIONAL. FAILURE TO COMPLY WITH THIS CLAUSE SHALL
EXONERATE THE MANUFACTURER FROM ANY RESPONSIBILITY.
2.1 Ground. In case it is installed with the optional foot support, make sure the ground where the appliance will be placed is able to
support the weight of the device. If not, you will need a load spreading plate for the equitable distribution of the equipment's weight.
In case of doubt, please consult a specialist.
2.2 Wall. If installed hanging, make sure the wall where the device will be placed has enough load capacity to support the weight of
the device —see the table below with the technical characteristics of the anchor. If this is not the case, a loading plate should be
used to share the load in order to have an equitable distribution of the device's weight. In case of doubt, ask a specialist.
:
2
:
2
:
2
:
2
Value
11-13 Pa
1,9 kg/h
6,4 g/s
81 %
7,26 kW
5 – 8,5 kW
0,09%
88,64 mg/Nm
69,78 mg/Nm
26,14 mg/Nm
11,9 Pa
139 kg
3 kg
200 mm
330 mm
4000 mm
150 mm
100 mm
1000 mm
200 mm
300 mm
238º C
INTERMITTENT
NOT SHARED
NATURAL WOOD
12-20% - two years under cover
2018
18-17172-819/944
3
3
3
8