Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
installation
(continued)
discharge (continued)
The discharge may pass straight through the wall to the
outside, provided that the wall opening is protected - by
means of a grating - against rain, leaves, and the like getting
in. The passage of the discharge may not be restricted by
the wall grating by more than 20%.
We advise the use of as large a discharge duct as possible.
A duct with a smaller diameter will have a low extraction
capacity and produce higher noise levels. Bends produce
resistance. Make sure that the duct has a smooth run and
has as few bends as possible. Draw the flexible pipe out as
far as possible. Before starting to drill, check that there are
no installed pipes present.
The extractor hood WU1111PM has 3 extraction settings: up,
left or right. The extractor is as standard used in the up
position. Alternatively, you can also turn the motor to direct
the exhaust either left or right:
1. Unscrew the 4 screw fasteners of the motor and remove
2. Unscrew the 4 screws from the grill (left or right).
3. Place the grill over the top hole and attach it using the 4
4. Place the motor tilted in the side hole and secure it using
The WU1511PX has 3 extraction settings. 2 connecting
pieces are supplied for this.
-
-
Note: For the WU1511PX, only an external motor of type
WM105BI may be used.
GB 10
the motor.
screws.
the 4 screws.
A 180-mm round piece for extraction upwards.
A 220x90-mm plate for extraction left or right.
assembly
building-in dimensions
320
935
235
1100
45
1120
460
480
WU1111PM
217,5
Hole pattern WU1111PM
300
128
Hole pattern WU1511PX
396
1156
125
1500
45
1520
700
720
WU1511PX
1120
1100
935
480
237,5
1520
1500
1156
300
900
128
GB 11
Publicité
Table des Matières
