Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
assembly
building-in dimensions
290
360
540
785-1155
595
70
900
500
GB 10
290
360
540
820-1190
550
500
WS9011HM
assembly
100
1200
WS1211HM
(continued)
installation wall hood
The most important dimensions are shown on the previous
page. You can set the height of the telescopic pipe. Take the
allowable tolerances into account. Position the discharge
and the electrical connection in such a way that it will be
easy to hook up the hood.
marking
Draw the mounting holes on the wall using the template.
Drill the 4 mounting holes for the extractor hood and the 4
mounting holes for the brackets.
Insert the plugs into the 8 drilled holes.
Screw 2 screws into the lowest holes. Leave the screws
protruding 2 mm from the wall (see diagram).
fitting the hood
Hang the extractor hood on the 2 screws.
Screw in the screws on the top side of the extractor hood
(see diagram).
Screw the inside of the hood to the wall.
Attach the pipe connection to the extractor hood using the
screws (see diagram).
GB 11
Publicité
Table des Matières
