Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
for your safety
please note
This appliance should be connected by a
registered fitter. Damage arising from incorrect
connection or incorrect fitting is not covered by
the guarantee.
Never flambe under an extractor. The high
flames can cause fire. Even if the ventilator is
switched off.
When deep-frying, always keep a close watch.
If the appliance is used together with
equipment which uses gas or other fuels, then a
sufficient supply of fresh air must be ensured.
Switch the extractor hood on before starting to
cook. After cooking, allow the extractor hood to
continue to run for approx. 10 minutes. This can
also be done automatically (see 'automatic
continued running').
Clean the appliance regularly, as shown in
'maintenance'. This minimises the chance of a
fire starting.
Switch off the electricity before replacing the
light bulbs! Only use the same sort of light bulbs
with the same Wattage.
GB 2
In case a reparation is necessary, disconnect
the appliance before starting the reparation. It
is recommended that you do this by removing
the plug from the socket or by setting the
isolation switch to zero.
remote control
switching lighting on and off
Press the lighting button
The lighting comes on.
Press the button
switching on the fan
Press button
The extractor hood comes on at setting 1. The display on the
extractor hood will indicate the selected setting (see "main
switch/display", page 4).
adjusting the extractor capacity
Press button
The maximum setting you can select is setting 4.
switching off the fan
Press button
switch/display", page 4).
After 1 minute the display will switch itself off automatically.
automatic continued operation
Choose the fan setting desired and press button
The extractor hood remains at the selected setting for 10
minutes, after which the extractor hood is automatically
switched off. The selected setting will flash on the
display.
You can change the setting during automatic continued
operation. Press button
switch off automatic continued operation at an earlier stage.
.
again and the lighting goes out.
.
of
to select a higher or lower setting.
until the display indicates 0 (see "main
.
until the display indicates 0 to
GB 3
Publicité
Table des Matières
