Sime BRAVA ONE BF Serie Manuel Pour L'utilisation, L'installation Et L'entretien page 79

EN
– press the button o to confirm (approximately 3 seconds) and
access the default value which is flashing
– press the button > and select "1" (LPG)
– press the button o for at least 3 seconds to confirm the mod-
ification. the value will stop flashing.
Procedure which MUST be carried out after:
– the nozzles for gas conversion
– changing the gas valve following a fault
– changing the the electronic board following a fault
– electrode
– fan
– burner
– go into the parameter section (if not already there) by press-
ing the buttons < and o
same time until "tS" (installer) appears on the 2 digits of the
display which alternate with "0.1" (parameter number) and a
(set value)
"2"
– keep the button > pressed and scroll through the parameters
until reaching parameter "tS 4.9"
– press the button o to confirm (approximately 3 seconds) and
access the default value which is flashing
– press the button > or < to set the value at "49"
– press the button o to confirm the modification The value will
stop flashing
(approximately 5 seconds) at the
– keep the button > pressed and scroll through the parameters
until reaching parameter "tS 7.0"
– press the button o to confirm (approximately 3 seconds) and
access the default value which is flashing
– press the button > or < to set the value "5"
– press the button o to confirm the modification The value will
stop flashing
– exit the parameter section by pressing and holding down the
buttons < and o
at the same time
until the delivery temperature is displayed.
m
IMPORTANT
To complete this task the user MUST carry out the fol-
lowing procedure.
(approximately 5 seconds)
79