Unpacking And Inspection; Features - Beha-Amprobe 2100-Delta Manuel De L'utilisateur

A voltage tester of relatively low internal impedance,
compared to the reference value of 100 kΩ, will not indicate
all interference voltages having an original voltage value above
the ELV level. When in contact with the parts to be tested,
the voltage tester may discharge temporarily the interference
voltage to a level below the ELV, but it will be back to the
original value when the voltage tester is removed.
When the indication "voltage present" does not appear, it is
highly recommended installing earthing equipment before work.
A voltage tester of relatively high internal impedance,
compared to the reference value of 100 kΩ, may not permit
to clearly indicate the absence of operating voltage in case of
presence of interference voltage.
When the indication "voltage present" appears on a part that
is expected to be disconnected of the installation, it is highly
recommended confirming by another means (e.g. use of an
adequate voltage tester, visual check of the disconnecting point
of the electric circuit, etc.) that there is no operating voltage on
the part to be tested and to conclude that the voltage indicated
by the voltage tester is an interference voltage.
A voltage tester declaring two values of internal impedance has
passed a performance test of managing interference voltages
and is (within technical limits) able to distinguish operating
voltage from interference voltage and has a means to directly or
indirectly indicate which type of voltage is present.
Warning: Read Before Using
W
To avoid possible electric shock or personal injury:
• The operating instructions contain information and
references required for safe operation and use of the voltage
tester. Before using the voltage tester, read the operating
instructions carefully and follow them in all respects.
• Failure to follow the instructions or to comply with
warnings and references may result in hazard to the user
and damage to the voltage tester.
• If the voltage tester is used in a manner not specified
by the manufacturer, protection provided by the voltage
tester may be impaired.
• Comply with local and national safety requirements.
• Use proper protective equipment as required by local or
national authorities.

UNPACKING AND INSPECTION

Your shipping carton should include:
1 2100-Delta Voltage Tester with Current-Function
1 Holster
2 GS 38 protective probe caps
2 4mm Ø test probe extension (screwable)
2 1.5V alkaline batteries, IEC LR03 (installed)
1 User manual
If any of these items are damaged or missing, return the
complete package to the place of purchase for an exchange.

FEATURES

The Beha-Amprobe 2100-Delta is a rugged and easy-to-use
two pole voltage tester for voltage, continuity and current
checks. The 2100-Delta is for electricians in residential,
industrial, and commercial applications for use in a wide voltage
range and safety rating are built according to latest voltage
tester standard EN 61243-3:2014 and are GS approved.
• AC and DC voltage test with LED and LC display.
• Voltage range: 1 to 1000 V AC (15...800 Hz) and 1 to
1500 V DC(±)
• Safety rating (overvoltage category): CAT IV / 600 V,
CAT III / 1000 V
• Automatic AC/DC voltage detection, indication of polarity
• Vibration motor in addition to voltage indication
• Open clamp meter for current measurement up to 200 A
• Two pole phase rotation indication –no third hand required.
Separate indicators for "Right" and "Left" rotation.
4