Symbols; Safety Information - Beha-Amprobe 2100-Delta Manuel De L'utilisateur

2100-Delta Voltage Tester with Current-Function TRMS
21
22
23
21
Data HOLD indicator
22
AC/ DC and polarity indicators
23
Function symbols from left to right,
upper row: - voltage test (measurement) "V" + continuity "Rx"
lower row: - voltage mode „<10V"
24
Low battery indication
25
Four digit - seven segment display

SYMBOLS


Caution! Risk of electric shock.
W Caution! Refer to the explanation in this manual.
Application of current sensor to and removal from
UNINSULATED HAZARDOUS LIVE conductors
is permitted.
The equipment is protected by double insulation or
T
reinforced insulation.
Equipment for working under live voltage
P
Complies with European Directives.
This product complies with the WEEE Directive marking
requirements. The affixed label indicates that you must
not discard this electrical/electronic product in domestic
household waste. Product Category: With reference
=
to the equipment types in the WEEE Directive Annex I,
this product is classed as category 9 "Monitoring and
Control Instrumentation" product. Do not dispose of
this product as unsorted municipal waste.
Battery

SAFETY INFORMATION

The two pole voltage tester and test probes complies with:
IEC 61243-3:2014, EN 61243-3:2014, DIN VDE 0682-401:2015
Dust/water ingress protection IP64 per EN 60529
Electromagnetic Compatibility (EMC): IEC 61326-1
The current measurement function (open jaw) on this tester
complies with IEC/EN 61010-1 and IEC/EN 61010-2-032
Measurement Category III is applicable to test and measuring
circuits connected to the distribution part of the building's low-
voltage MAINS installation.
Measurement Category IV is applicable to test and measuring
circuits connected at the source of the building's low-voltage
MAINS installation.
For Use by Competent Persons
Anyone using this voltage tester should be knowledgeable and
trained about the risks involved with measuring voltage and
current, especially in an industrial setting, the importance of
taking safety precautions and of testing the voltage tester before
and after using it to ensure that it is in good working condition.
Depending on the internal impedance of the voltage tester
there will be a different capability of indicating the presence
or absence of operating voltage in case of the presence of
interference voltage.
- current measurement "A"
- resistance measurement "Ω"
- cable break detection "EF
- frequency measurement "Hz"
- low resistance indication "L Rx"
- diode test " "
3
24
25
"